Troubleshooting steps
medium
SINUMERIK 808D
25110 – Spindle speed not reached
Spindle speed did not reach commanded value
Details
alarm
Error typeSpindle speed
MeaningMechanical problem drive fault overload
Typical causesCheck mechanical condition verify drive reduce load
Solutionsmedium
Catalog references
System Information
SINUMERIK 808D25110
Utilities
Troubleshooting Steps
Other alarms
Other SINUMERIK 808D Alarms
22050 – Channel not ready
NC channel failed to initialize or is in error state
25000 – Emergency stop active
Emergency stop button pressed or safety circuit activated
25050 – Axis hardware fault
Axis drive or motor detected a hardware fault condition
25060 – Axis software limit switch
Axis reached software limit switch position
25080 – Axis following error
Axis position following error exceeded tolerance
FAQ
Common questions
What speed?
Check commanded vs actual speed in diagnostics
Community
Discussion & Experiences
Share your experience, solutions, or ask questions about this error code. Help others troubleshoot!
Loading comments...