Troubleshooting steps
high
SINUMERIK 808D
25200 – Tool changer fault
Tool changer mechanism error
Details
alarm
Error typeTool changer
MeaningMechanical binding tool stuck limit switch fault
Typical causesCheck tool changer mechanism verify tool is not stuck check limit switches
Solutionshigh
Catalog references
System Information
SINUMERIK 808D25200
Utilities
Troubleshooting Steps
Other alarms
Other SINUMERIK 808D Alarms
22050 – Channel not ready
NC channel failed to initialize or is in error state
25000 – Emergency stop active
Emergency stop button pressed or safety circuit activated
25050 – Axis hardware fault
Axis drive or motor detected a hardware fault condition
25060 – Axis software limit switch
Axis reached software limit switch position
25080 – Axis following error
Axis position following error exceeded tolerance
FAQ
Common questions
Can I manually change?
Some machines allow manual tool change in emergency
Community
Discussion & Experiences
Share your experience, solutions, or ask questions about this error code. Help others troubleshoot!
Loading comments...