Troubleshooting steps
high
SINUMERIK 828D
25050 – Axis hardware fault
Axis drive or motor detected a hardware fault condition
Details
alarm
Error typeAxis fault
MeaningDrive fault motor fault encoder fault wiring fault
Typical causesCheck axis drive status verify motor operation test encoder check wiring connections
Solutionshigh
Catalog references
System Information
SINUMERIK 828D25050
Utilities
Troubleshooting Steps
Other alarms
Other SINUMERIK 828D Alarms
22050 – Channel not ready
NC channel failed to initialize or is in error state
25000 – Emergency stop active
Emergency stop button pressed or safety circuit activated
25060 – Axis software limit switch
Axis reached software limit switch position
25080 – Axis following error
Axis position following error exceeded tolerance
25100 – Spindle hardware fault
Spindle drive detected a hardware fault
FAQ
Common questions
Which axis?
Alarm message indicates the affected axis. Check drive for that specific axis
Community
Discussion & Experiences
Share your experience, solutions, or ask questions about this error code. Help others troubleshoot!
Loading comments...