Troubleshooting steps
medium
SINUMERIK 828D
30030 – Drive temperature
Drive temperature exceeded limit
Details
alarm
Error typeDrive temperature
MeaningInsufficient cooling overload continuous operation
Typical causesCheck cooling system allow drive to cool reduce load
Solutionsmedium
Catalog references
System Information
SINUMERIK 828D30030
Utilities
Troubleshooting Steps
Other alarms
Other SINUMERIK 828D Alarms
22050 – Channel not ready
NC channel failed to initialize or is in error state
25000 – Emergency stop active
Emergency stop button pressed or safety circuit activated
25050 – Axis hardware fault
Axis drive or motor detected a hardware fault condition
25060 – Axis software limit switch
Axis reached software limit switch position
25080 – Axis following error
Axis position following error exceeded tolerance
FAQ
Common questions
How long to cool?
Typically 15-30 minutes depending on drive size
Community
Discussion & Experiences
Share your experience, solutions, or ask questions about this error code. Help others troubleshoot!
Loading comments...