Troubleshooting steps
high
SINUMERIK 828D
25000 – Emergency stop active
Emergency stop button pressed or safety circuit activated
Details
alarm
Error typeEmergency stop
MeaningEmergency stop button pressed safety circuit activated
Typical causesRelease emergency stop button check safety circuits verify all safety conditions satisfied
Solutionshigh
Catalog references
System Information
SINUMERIK 828D25000
Utilities
Troubleshooting Steps
Other alarms
Other SINUMERIK 828D Alarms
22050 – Channel not ready
NC channel failed to initialize or is in error state
25050 – Axis hardware fault
Axis drive or motor detected a hardware fault condition
25060 – Axis software limit switch
Axis reached software limit switch position
25080 – Axis following error
Axis position following error exceeded tolerance
25100 – Spindle hardware fault
Spindle drive detected a hardware fault
FAQ
Common questions
How do I reset?
Release emergency stop button and press reset. Check all safety interlocks first
Community
Discussion & Experiences
Share your experience, solutions, or ask questions about this error code. Help others troubleshoot!
Loading comments...